Hydro-Flo Oil Water Separators
Hydro Flo Technologies above ground Oil Water Separators are designed to
accommodate flow rates as low as 1 gallon per minute up to 1500 gallons per minute. They are designed
to handle free and dispersed non-emulsified oil, and some settleable
solids. The primary function of the oil water separator is to
remove gross quantities of free oil before further treatment is
applied. However, in some cases, oil water separators
can be used as end of pipe treatments as needed.
At Hydro-Flo, we offer a variety of sizes and designs for
oil water separation. Our designs are done in accordance to
API criteria, and utilize our DYNA-PAK cross corrugated coalescing
media. Through the use of our coalescing DYNA-PAK media,
Hydro-Flo oil water separators will create an effluent that contains
less than 10 mg/l of oil droplets greater than 30 microns. Hydro-Flo will properly size and recommend the top
performing and most cost effective solution for your application.
Hydro-Flo Oil Water Separators are available in
fiberglass construction, A36 carbon steel, and T304 stainless steel.
Our wide range of coatings are well suited to handle even the most
corrosive applications and will provide a protective layer that will
help ensure proper equipment operation for the long term.
Typical Applications
: Industrial Wastewater treatment,
Petroleum Refinery, Groundwater Remediation, Food Processing and
Rendering, Chemical Processing, Metal Finishing Industries,
Equipment Washpad Recycling.
Available Accessories
for Oil Water Separators
 | Coalescing Media
Our media is available with three
different spacings, 1/2", 3/4" and 1-1/4" in order to provide the
flexibility to handle any wastestream regardless of solids content
and viscosity. Our media is also available in PVC, CPVC, FRP,
Polypropylene and Stainless Steel to meet all of your chemical
applications.
|
| Sight Glasses
Our sight glasses are available in
both the rigid and flexible form to allow oil flow from the
Oil/Water Separator to either integral storage or external tanks
or drums. Our sight glasses can be equipped with level sensors to
indicate level conditions for your system needs.
|
| Heaters
We can provide immersion heaters to
prevent freezing in any of our equipment configurations.
|
| Platforms
We can provide platforms for all of
our equipment in order to provide gravity flow to downstream
equipment or increase floor area for other equipment.
|
| Fittings
We are unlimited in our ability to
supply custom fitting configurations for your application needs.
|
| Mounting Flanges
All of our equipment can be
supplied with mounting flanges so that anchoring can be made as
efficient as possible.
|
| Restraints
We can offer special restraint
configurations to meet seismic and wind loading specifications for
any project.
|
